Cooler motor manufacturer, Faridabad, Haryana. ISO 9001:2015 certified. Facebook+91 88264 67259+91 90154 04168nexpowerinfra@gmail.com
NEXPOWER INFRAAir cooler motors. Made in India.
WhatsApp

Why cooler motors burn in May and June

The seven common reasons an air cooler motor burns in peak summer: wrong blade, low voltage, weak capacitor, dry bush, water, blocked air and joined speed wires.

By the NEXPOWER technical team · November 2026

A cooler motor almost never burns in March. It burns in the hottest weeks, when the cooler runs all day, the supply voltage is low and the pads are choked. Nearly every burnt winding we see comes from one of seven causes.

1. Blade too big or too steep for the motor

The blade is the load. A larger or steeper blade needs more torque, the current rises above the nameplate value and the winding overheats. Match the blade to the stack: see our blade size chart.

2. Low voltage

On low voltage the motor slows down and draws more current to turn the same blade. In low-voltage areas choose the next stack size or a lighter blade.

3. Weak or wrong capacitor

A weak capacitor makes the motor start slowly and hum. A larger value than the nameplate does not give more power; it raises winding current and heat.

4. Dry bush or worn bearing

A dry bush drags on the shaft. The motor works harder, runs hot and one day does not start at all while still switched on.

5. Water on the motor

Dripping water breaks down the insulation. Keep the drip cover in place and route the wires away from the water path.

6. Blocked air path

Choked pads and closed rooms cut the air flow that also cools the motor.

7. Two speed wires joined

Joining two speed leads shorts part of the winding. Connect only one speed lead at a time through the switch.

A one-minute check

Run the cooler with wet pads and the body closed, and measure the current with a clamp meter at full speed. If it is at or below the nameplate amperes, blade and motor are matched. If it is higher, change the blade or move up a stack.

More articles

Comments

Add your experience or question. Please keep it polite and technical.

Need a rate for your quantity?

Send the model, stack size and quantity. Minimum 50 pieces per model.

WhatsAppCall now