Aluminium or copper winding in a cooler motor
Aluminium winding versus copper winding in air cooler motors: conductivity, heat, weight, joints, price and when copper is worth paying for.
By the NEXPOWER technical team · November 2026
Dealers ask this more than any other question. Both metals make a working motor. The difference is in how much margin the motor has when conditions are bad.
| Point | Aluminium winding | Copper winding |
|---|---|---|
| Conductivity | About 61% of copper, so a thicker wire is needed for the same resistance | Higher, so less heat for the same slot space |
| Weight and price | Lighter and cheaper | Heavier and costlier |
| Heat margin | Less margin on low voltage or an oversize blade | More margin under overload |
| Joints | Need care: aluminium oxidises, so joints must be made properly | Easy to solder and reliable |
| Repair | Rewinding possible, joints again need care | Simple to rewind |
Which should you buy
- For a correctly matched blade and normal voltage, a well-designed aluminium-wound motor does the job at a lower price. This is our standard supply.
- For low-voltage areas, long running hours, tent and commercial coolers, copper is worth the extra price. We wind in copper on order.
- Whatever the metal, the design must suit it. A motor wound in aluminium to a copper design will run hot.
Ask the seller plainly which metal the winding is, and compare prices only between motors of the same metal and the same stack.
Comments
Add your experience or question. Please keep it polite and technical.